1. No feeding is required during debugging, but the guide screws on the guide plate must be raised first, and then the punch hammer must be slowly adjusted to the bottom dead center using a inching method. At the same time, special attention must be paid to not pressing the floating rod too low on the guide plate, otherwise it will cause the floating rod to bend or break.
2. When starting the non-woven bag making machine for continuous operation, it is necessary to adjust the screw by rotating the feeding machine in a clockwise direction. The slider should move slightly slower so that it can be seen whether the slider touches the nylon gasket and the length adjustment screw when reciprocating.
3. When testing the machine, the slider moves back and forth. If it only touches the nylon gasket and does not touch the length adjustment screw, it is because the floating rod does not descend deeply enough. The guide screw on the punch needs to be slowly adjusted downwards.
4. If the non-woven bag making machine only touches the length adjustment screw and does not touch the nylon gasket when the slider moves back and forth, it is because the floating rod has dropped too deeply, and the guide screw on the punching machine needs to be slowly raised.
